Follow SEM's standard operating procedure (SOP) for duplicating OEM textures on raw plastic or painted surfaces. 

Download SOP

1. REPAIR DAMAGE

Sand any shallow scratches or scuffs until smooth or, if extensive damage is present, refer to Plastic Repair Standard Operating Procedure first.

2. CLEAN

Clean with Scuff & Clean and a gray scuff pad or a nylon bristle brush. Rinse with water and dry with clean, lint-free cloth.

FOR RAW PLASTIC: Clean with Plastic & Leather Prep or XXX Universal Surface Cleaner.
FOR PAINTED SURFACES: Clean with SEM Solve or XXX Universal Surface Cleaner.

Wipe clean in one direction with clean, lint-free cloth.

3. PREP

Mask the area to be sprayed.

FOR RAW PLASTIC: Apply Adhesion Promoter per instructions.
FOR PAINTED SURFACES: Sand with a gray scuff pad. Blow off and re-clean with SEM Solve.

4. APPLY TEXTURE

Apply Texture Coating in 1 light mist coat 18" - 24" from surface. Allow to flash for 10 minutes.
Note: Be sure to apply lightly enough so that raised textured spray does not flow together.

5. SAND

Sand flat surfaces with P500 - 1000 grit sanding pad and use a gray scuff pad on sharp edges and corners. Blow off and wipe with a tack rag.

6. PAINT

Apply Bumper Coater™ or Trim Black per instructions.

Check local VOC regulations to ensure compliance of all products in your area. Always wear OSHA required personal protection equipment (PPE) to ensure your safety.